IBM System x3300 M4, Инструкция по установке и обслуживанию

Страница: 436 / 470

12. If you are instructed to return the microprocessor, follow all packaging
instructions, and use any packaging materials for shipping that are supplied
to you. Do not return the microprocessor installation tool.
Replacing a microprocessor and heat sink
Attention:
When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details about handling these devices, see
“Handling static-sensitive devices” on page 39.
Notes:
v
If your server comes with one Intel Pentium 1400 series microprocessor, the
second microprocessor socket is not used. The server supports only one Intel
Pentium microprocessor. If you plan to install two Intel Xeon microprocessors in
the server, you must first remove the Intel Pentium microprocessor that came
with the server.
v
See “Installing a microprocessor and heat sink” on page 92 for notes and other
information that you must consider when you install a microprocessor.
v
Be extremely careful, the pins on the socket are fragile. Any damage to the pins
may require replacing the system board.
v
Use the microprocessor installation tool that came with the new microprocessor
to remove the microprocessor from the server. Failure to use the microprocessor
tool may cause damage to the pins on the socket. Any damage to the pins may
require replacing the system board.
To replace an additional microprocessor and heat sink, complete the following
steps:
1. Read the safety information that begins on page Safety and “Installation
guidelines” on page 36.
2.
Turn off the server (see “Turning off the server” on page 24) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
3. Carefully turn the server on its side so that it is lying flat, with the cover
facing up.
Attention: Do not allow the server to fall over.
4. Unlock and remove the left-side cover (see “Removing the left-side cover” on
page 39).
5. Remove the air baffle (see “Removing the air baffle” on page 41)
6. Remove the fan assembly (see “Removing the fan assembly” on page 42)
418
System x3300 M4 Type 7382: Installation and Service Guide