IBM System x3300 M4, Инструкция по установке и обслуживанию

Страница: 139 / 470

Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
v
Load Default Settings
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
v
Exit Setup
Select this choice to exit from the Setup utility. If you have not saved the
changes that you have made in the settings, you are asked whether you want to
save the changes or exit without saving them.
Passwords
From the User Security menu choice, you can set, change, and delete a power-on
password and an administrator password. The User Security choice is on the full
Setup utility menu only.
If you set only a power-on password, you must type the power-on password to
complete the system startup and to have access to the full Setup utility menu.
An administrator password is intended to be used by a system administrator; it
limits access to the full Setup utility menu. If you set only an administrator
password, you do not have to type a password to complete the system startup, but
you must type the administrator password to access the Setup utility menu.
If you set a power-on password for a user and an administrator password for a
system administrator, you can type either password to complete the system
startup. A system administrator who types the administrator password has access
to the full Setup utility menu; the system administrator can give the user authority
to set, change, and delete the power-on password. A user who types the power-on
password has access to only the limited Setup utility menu; the user can set,
change, and delete the power-on password, if the system administrator has given
the user that authority.
Power-on password:
If a power-on password is set, when you turn on the server, the system startup
will not be completed until you type the power-on password. You can use any
combination of 6 to 20 printable ASCII characters for the password.
When a power-on password is set, you can enable the Unattended Start mode, in
which the keyboard and mouse remain locked but the operating system can start.
You can unlock the keyboard and mouse by typing the power-on password.
If you forget the power-on password, you can regain access to the server in any of
the following ways:
v
If an administrator password is set, type the administrator password at the
password prompt. Start the Setup utility and reset the power-on password.
v
Remove the battery from the server and then reinstall it. See “Removing the
system battery” on page 375 for instructions for removing the battery.
v
Clear CMOS data by using the clear CMOS jumper (see “System-board switches
and jumpers” on page 31 for more information).
Attention: Before you change any switch settings or move any jumpers, turn
off the server; then, disconnect all power cords and external cables. See the
safety information that begins on page Safety. Do not change settings or move
jumpers on any system-board switch or jumper blocks that are not shown in this
document.
Chapter 3. Configuration information and instructions
121