HRC NSF250R 2012, Руководство пользователя и список запчастей

Страница: 17 / 300

1-7
Operating Instruction
1-DOWN AND 5-UP
To change the pattern to "1-DOWN and 5-UP", rein-
stall the change arm upside down (rod connecting
end facing down).
Before running, apply grease to the change pedal
pivot surface.
(1) STEERING DAMPER (2) ADJUSTER
(A) HARD (B) SOFT
Steering Damper
Turn the adjuster clockwise to increase damping,
counterclockwise to decrease damping. There are
12 – 17 notches between minimum and maximum.
Do not force the adjuster to pass its limit.
Standard setting: Full soft position
Improper handling or failure to install the damper
properly may damage the steering damper.
(1) THICK WASHER (2) SPHERICAL BEARING
• When installing the damper on the frame, pay
careful attention to prevent the piston rod from
being applied with excessive bending force
beyond the allowable rotation angle of the spher-
ical bearing.
• Handle carefully to avoid scratching, damaging or
leaving foreign substances on the rod.
• Do not try to disassemble the steering damper.
• The steering damper must first be set at the stan-
dard (full soft) position, than adjust as required.
• At steering damper installation, set the thick
washer (2.3 mm) between the spherical bearing
and frame, and the spherical bearing and bottom
bridge.
1-UP AND 5-DOWN
(1) CHANGE ARM (2) CHANGE ROD
(3) GEARSHIFT PEDAL
(1) CHANGE ARM (2) CHANGE ROD
(3) GEARSHIFT PEDAL
(1)
(2)
(B)
(A)
(1)
(1)
(2)
(2)
(1)
(2)
(3)
(1)
(2)
(3)