HRC NSF250R 2012, Руководство пользователя и список запчастей

Страница: 158 / 300

5-8
Frame Servicing
(1) FORK SLIDER
Fork Slider
･
Inspect the fork slider sliding surfaces for damag-
ing, whenever the oil seal is replaced due to oil
leaks.
Check the slider for score marks, scratches and
excessive or abnormal wear.
Set the slider on V-blocks and measure the runout.
Take 1/2 the total indicator reading to determine the
actual runout.
Service limit: 0.20 mm (0.008 in)
Assembly
･
Clean the parts thoroughly with non-flammable or
high flash point solvent before assembly.
･
When the bushing, fork slider, outer tube are
replaced, break in your NSF at the standard set-
ting.
･
For optimum fork performance, the fork fluid
should be used the Honda Ultra Cushion Oil
Special (SAE 5W), Showa SS05 Operation Oil or
equivalent.
･
Vegetable oils is harmful to the oil seals, resulting
in oil leaks.
(1) NEW SLIDER BUSHING (2) GUIDE BUSHING
(3) BACK-UP RING (4) NEW OIL SEAL
(5) STOP RING
Wrap the end of the slider with a tape.
Install the stop ring.
Coat the new oil seal lips with recommended fork
fluid and install with its seal mark facing the stop
ring.
Remove the tape.
Install the back-up ring.
Be careful not to scratch the teflon coating of the
bushings.
Coat the guide bushing with recommended fork
fluid and install it.
Coat new slider bushing with recommended fork
fluid.
Always replace the slider bushing when the fork is
disassembled.
Carefully install the slider bushing with your finger.
Do not pry open the bushing more than necessary.
Coat the slider and guide bushings with recom-
mended fork fluid.
Install the slider into the outer tube.
(1)
(1)
(2)
(3)
(4)
(5)