HRC NSF250R 2012, Руководство пользователя и список запчастей

Страница: 212 / 300

7-10
Machine Setting
(1) FORK SET COLLAR (2) STOPPER RING
(3) FORK BOLT
Fork Spring Replacement
Support the machine using the maintenance stand.
Remove the bolts and front fender.
Remove the lower radiator mounting bolt to avoid
damaging the radiator, the front tire will interfere
with the radiator.
Remove the stop rings.
Avoid damaging the fork cap threads, loosen the top
bridge pinch bolts.
If the fork bolts in both right and left forks are
removed from the outer tube, the fork will bottom
suddenly. Hold the machine and loosen the fork
bolt, lower the machine slowly until the bottom
bridge contacts the tire.
Installing the Fork Set Collar (51481-NX4-610) onto
the axle holder.
Record the fork tube height..
Loosen the bottom bridge pinch bolts and pull the
outer tube down onto the fork set collar.
(1) SPRING COLLAR (2) SPRING SEAT STOPPER
(3) FORK BOLT
Push down on the spring collar and spring seat stop-
per and hook them under lock nut.
Hold the cut-out of the rebound adjuster with a 17
mm spanner, then loosen the fork bolt.
Be careful not to lose the rebound adjuster lock nut.
(1) SPRING SEAT STOPPER
(2) SPRING COLLAR (3) JOINT PLATE
(4) FORK SPRING
Remove the following:
– spring seat stopper
– spring collar
– spring joint plate
– fork spring
Install the spring with its identification mark (num-
ber of coils) facing up.
Install the parts in the reverse order of removal.
Pull the outer tube up as much as the fork tube
height recorded during removal and tighten the bot-
tom bridge pinch bolts.
Torque:
Bottom bridge pinch bolt:
22 N•m (2.2 kgf•m, 16 lbf•ft)
Fork bolt: 34 N•m (3.5 kgf•m, 25 lbf•ft)
Top bridge pinch bolt:
22 N•m (2.2 kgf•m, 16 lbf•ft)
(2)
(3)
(1)
(1)
(2)
(3)
(4)
(3)
(2)
(1)