HRC NSF250R 2012, Руководство пользователя и список запчастей

Страница: 48 / 300

3-8
Service and Maintenance
(1) UPPER LEVEL MARK
(2) LOWER LEVEL MARK
Engine Oil/Oil Filter
Oil Level Inspection
Start the engine and let it idle for a few minutes.
Stop the engine, support the machine using a main-
tenance stand.
Wait for a few minutes.
Remove the machine from a maintenance stand and
support it with upright position on level ground.
Check that the oil level is between the upper and
lower level marks in the inspection window.
(1) OIL FILLER CAP
(2) DRAIN BOLT
Oil Change
Change the engine oil with the engine warm.
Support the machine using a maintenance stand to
assure complete and rapid draining.
1. Cut the locking wires from the oil filler cap and oil
drain plug.
2. Remove the oil filler cap.
3. Place an oil drain pan under the engine and
remove the drain bolt.
4. After the oil has completely drained, make sure
that the sealing washer is in good condition and
reinstall the drain bolts. Tighten the drain bolt to
the specified torque.
Torque: 16 N•m (1.6 kgf•m, 12 lbf•ft)
(2)
(1)
(1)
(2)
(2)
(1)
(2)
(1)
(1) CRANKSHAFT HOLE CAP
(2) O-RING
(1) TIMING HOLE CAP
(2) O-RING
Apply grease to the new O-ring and install it onto
the crankshaft hole cap. Install and tighten the
crankshaft hole cap to the specified torque.
Torque: 15 N•m (1.5 kgf•m, 11 lbf•ft)
Apply grease to the new O-ring and install it onto
the timing hole cap. Install and tighten the timing
hole cap to the specified torque.
Torque: 6 N•m (0.6 kgf•m, 4.4 lbf•ft)