Removal and Replacement Procedures
IMPORTANT:
If no expansion board is installed in PCI-X slot 1, remove the expansion slot cover.
6. Remove the Torx T-15 screw holding the basket in place. The screw is located between
slots 3 and 4 in the rear
(1)
.
7. Pull up on the retaining pins securing the hot-plug expansion board basket to the system
tray
(2)
.
8. Press the plastic sleeve outward until the retaining tab snaps clear of the rear panel
(3)
.
9. Lift the hot-plug expansion board basket from the system tray
(4)
.
Figure 2-38: Removing the hot-plug expansion board basket
Reverse steps 1 through 9 to replace the hot-plug expansion board basket.
PCI Backplane
To remove the PCI backplane:
1. Prepare the server for a non-hot-plug procedure. Refer to “Preparing the Server for
Non-Hot-Plug Procedures” in this chapter.
2. Remove the front bezel door (tower model only), and lay the server on its side with the
access panel facing upward. Refer to “Removing the Front Bezel Door (Tower Model
Only)” in this chapter.
3. Remove the access panel. Refer to “Removing the Access Panel” in this chapter.
4. Remove the memory board. Refer to “Removing the Memory Board” in this chapter.
2-48
HP ProLiant ML570 Generation 2 Server Maintenance and Service Guide
Содержание ProLiant ML570 Generation 2
Страница 6: ......
