Removal and Replacement Procedures
Configuring the Memory
Configuring the server’s memory system requires configuring both hardware and software.
To configure the memory:
1. Remove the memory board. Refer to “Removing a Memory Board” in this chapter.
2. Install the required DIMMs based on the desired memory configuration. Be sure to
follow all DIMM installation requirements. Refer to the “DIMM Installation
Requirements” section in this chapter for each mode.
3. Install the memory board. Refer to “Installing a Memory Board” in this chapter.
4. Test the DIMMs:
a. Power on the server.
b. Press
the
F9 key to enter RBSU.
c. Select
Advanced Options.
d. Change
POST Speed Up to disable.
e. Press any key to return to the RBSU main menu.
f. Select
System Options.
g. Select
Advanced Memory Protection.
h. Select the desired memory mode.
i. Press
the
Esc key twice to go back to the main RBSU menu.
j. Press
the
F10 key to exit RBSU. The server reboots and tests all memory in the
system.
k. Once the memory has been tested, change POST Speed Up to enable for faster
system boot, if desired.
IMPORTANT:
To reconfigure the memory mode after initial setup, you must reboot the system and
enter RBSU.
2-24
HP ProLiant ML570 Generation 2 Server Maintenance and Service Guide
Содержание ProLiant ML570 Generation 2
Страница 6: ......