HP ProLiant ML570 Generation 2, Руководство по техническому обслуживанию и ремонту

Страница: 62 / 139

Removal and Replacement Procedures
7. Lift the PPM straight up from its slot.
Figure 2-33: Removing a PPM
Reverse steps 1 through 7 to replace a PPM.
IMPORTANT:
When installing a PPM, be sure the key slot in the PPM is aligned with the key in the
slot.
Processors
To remove a processor:
1. Prepare the server for a non-hot-plug procedure. Refer to “Preparing the Server for
Non-Hot-Plug Procedures” in this chapter.
2. Remove the front bezel door (tower model only), and lay the server on its side with the
access panel facing upward. Refer to “Removing the Front Bezel Door (Tower Model
Only)” in this chapter.
3. Remove the access panel. Refer to “Removing the Access Panel” in this chapter.
4. Remove the rear and front processor air baffles. Refer to “Processor Air Baffles” in this
chapter.
2-44 HP ProLiant ML570 Generation 2 Server Maintenance and Service Guide