HP ProLiant DL360 Gen10, Руководство пользователя, Страница: 57 / 145

17. Connect each power cord to the power source.
18. Power up the server ( Powering up the server on page 24).
19. Install drives.
Installing a 2 SFF HPE Smart Carrier M.2 (SCM) drive cage
Prerequisites
Hewlett Packard Enterprise recommends installing the P816i-a controller to support more than eight SAS/
SATA drives. Additional controller options are available. For more information, see the HPE DL360 Gen10
Server cabling matrix on the Hewlett Packard Enterprise website (
http://www.hpe.com/info/
CablingMatrixGen10 ).
Before installing this option, be sure you that have the following:
• The components included with the hardware option kit
• T-10 Torx screwdriver
• Additional cables, as needed. For more information, see
SFF cables on page 114.
• 2 SFF SAS/SATA drives, 4 uFF M.2 drives, or blanks
For more information, contact a Hewlett Packard Enterprise authorized reseller.
Procedure
1. Back up all server data.
2. Power down the server ( Power down the server on page 24).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack ( Extend the server from the rack on page 24).
b. Remove the server from the rack ( Remove the server from the rack on page 25).
5. Remove the access panel ( Remove the access panel on page 25).
6. Remove the universal media bay blank.
7. Install the drive cage.
Installing a 2 SFF HPE Smart Carrier M.2 (SCM) drive cage 57