HP ProLiant DL360 Gen10, Руководство пользователя

Страница: 100 / 145

8. Install the access panel ( Installing the access panel on page 25).
9. Install the server in the rack.
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server ( Powering up the server on page 24).
Installing the serial cable option
Prerequisites
Before installing this option, be sure you have the following:
• The components included with the hardware option kit
• T-10 Torx screwdriver
Procedure
1. Observe the following alerts:
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:
To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
2. Back up all server data.
3. Power down the server ( Power down the server on page 24).
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
a. Extend the server from the rack ( Extend the server from the rack on page 24).
b. Remove the server from the rack ( Remove the server from the rack on page 25).
100 Installing the serial cable option