horsch Maestro 16 SX, Руководство по эксплуатации

Страница: 91 / 158

AirSpeed single grain metering system | 10
60026387 • 01 • 03/2021 • en 91
10.2.3 Barrel
After the grain transfer in the metering unit the grain drops through the barrel to
the ground.
The sensor is the basis for monitoring the drilling process. The sensor detects each
grain and reports it to the computers.
These evaluate the data and times between grain signals and use this information to
calculate the variation coefficient (drilling accuracy), faults and double seeds.
The Barrel and the sensor must therefore be correctly assembled and fastened.
1
1 Spigot
Install the Barrel
The spigot on the Barrel locks the Barrel on the drill unit.
Spigot hooked up
1. Guide the Barrel on the front edge of the recess in the drill unit toward the
bottom.
2
3
2. Plug in the top locking bolt and secure it with a cotter pin (2).
3. Route the sensor cable behind the cable routing (3).