horsch Maestro 16 SX, Руководство по эксплуатации

Страница: 134 / 158

15 | Care and maintenance
134 60026387 • 01 • 03/2021 • en
Rotor Check for sticking cells and clean. daily
Motor bearing and housing
cover Check for condition and smooth running. prior to use
Distributor tower Check distributor and hoses for damage and blockage, clean the dis-
tributor. prior to use
Metering unit, single grain
with
Barrel
Overpressure connection Check for fastening and leak tightness 40 h
Transition to the Barrel Check the seat of the covering. 40 h
Barrel Check state and fastening at the pipe inlet. daily
Check pipe discharge for stuck material and damages
Clean Barrel with grain sensor. In case of strong contamination clean
several times per day.
Single grain metering unit Clean and remove deposits daily
Metering discs for wear 40 h
Push-out wheels for wear 40 h
Electrics
Electric lines Check for damage 40 h
Hydraulics
Hydraulic system and com-
ponents Check all hydraulic components and hoses for function, leak tight-
ness, fastening and chafing. 40 h
Leak oil return flow Return flow pressure max. 5 bar daily
PTO-shaft pump fan See chapter Pneumatics – drive with PTO-shaft pump
PTO-shaft pump Oil change – every 2,000 h / every 2 years, depending on which
comes earlier (workshop work)
Pneumatic brake
Brake system Check condition and function. daily
Brake lines and hoses Check for damages as well as crushing and kinking. daily
Air reservoir Drain air reservoir. daily
Coupling heads Clean line filter in the coupling heads. 40 h
Brake linings Check brake linings for wear. 40 h
Wheels
All wheels Check for damages (cracks, etc.) and wear and replace if necessary. daily
All wheels Retighten all wheel nuts.
M18 x 1.5 – 300 Nm
M22 x 1.5 – 510 Nm
M22 x 1.5 – 630 Nm (for flat collar nuts)
50 h
Bearings of carrying axle
journals Check clearance and adjust if necessary (workshop work) 120 h /
6 months