HEIDENHAIN TNC 620, Руководство пользователя

Страница: 203 / 521

Setup | Presetting without a 3D touch probe
Using touch probe functions with mechanical probes or
measuring dials
If you do not have an electronic 3-D touch probe on your machine,
you can also use all the previously described manual touch probe
functions (exception: calibration function) with mechanical probes or
by simply touching the workpiece with the tool.
Further information: "Using a 3-D touch probe (option 17)",
Page 204
In place of the electronic signal generated automatically by a 3-D
touch probe during probing, you can manually initiate the trigger
signal for capturing the probing position by pressing a key.
Proceed as follows:
Select any touch probe function by soft key
Move the mechanical probe to the first position to
be captured by the control.
To capture the position: Press the
Actual-position-capture
soft key
The control saves the current position.
Move the mechanical probe to the next position to
be captured by the control.
To capture the position: Press the
Actual-position-capture
soft key
The control saves the current position.
If required, move to additional positions and
capture as described previously
Preset
: In the menu window, enter the
coordinates of the new preset, confirm with the
SET PRESET
soft key, or write the values to a table
Further information: "Writing measured values
from the touch probe cycles to a datum table",
Page 213
Further information: "Writing measured values
from the touch probe cycles to the preset table",
Page 214
Terminate the probing function: Press the
END
key
If you try to set a preset in a locked axis, the control will
issue either a warning or an error message, depending on
what the machine tool builder has defined.
5
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
203