HEIDENHAIN TNC 620, Руководство пользователя

Страница: 232 / 521

Setup | Presetting with a 3-D touch probe (option number 17)
5
Corner as preset
Refer to your machine manual.
It depends on the machine whether you can compensate
workpiece misalignment with an offset (angle for table
rotation).
HEIDENHAIN only gives warranty for the function of the
probing cycles if HEIDENHAIN touch probes are used.
The manual "Corner as preset" probing function identifies the angle
and intersection of two straight lines.
Select the probing function: Press the
PROBING P
soft key
Position the touch probe near the first touch point
on the first workpiece edge
Select the probe direction by soft key
Probe: Press the
NC Start
key
Position the touch probe near the second touch
point on the same workpiece edge
Probe: Press the
NC Start
key
Position the touch probe near the first touch point
on the second workpiece edge
Select the probe direction by soft key
Probe: Press the
NC Start
key
Position the touch probe near the second touch
point on the same workpiece edge
Probe: Press the
NC Start
key
Preset
: Enter the X and Y coordinates of the
preset in the menu window
Apply with the
SET PRESET
soft key
Further information: "Writing measured values
from the touch probe cycles to a datum table",
Page 213
Further information: "Writing measured values
from the touch probe cycles to the preset table",
Page 214
Terminate the probing function: Press the
END
soft key
232
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022