HEIDENHAIN TNC 620, Руководство пользователя

Страница: 390 / 521

HEROS functions | Window manager
10
Remote Service
In conjunction with the remote service setup tool, TeleService from
HEIDENHAIN offers the possibility to establish encrypted end-to-end
connections between a service computer and a machine.
To enable the HEIDENHAIN control to communicate with the
HEIDENHAIN server, the control needs to be connected to the
Internet.
Further information: "Network settings window", Page 413
In its basic state the firewall of the control blocks all incoming and
outgoing connections. Therefore, the firewall settings must be
adjusted or the firewall must be deactivated for the duration of the
service session.
Setting up the control
Proceed as follows to deactivate the firewall:
Open the task bar at the bottom edge of the screen
Press the green HEIDENHAIN button to open the
HEROS menu
Select the
Settings
menu item
Select the
Firewall
menu item
The control opens the
Firewall settings
dialog.
Deactivate the firewall by clearing the
Active
option on the
Firewall
tab.
Press the
Apply
button to save the settings
Press the
OK
button
The firewall is disabled.
Remember to activate the firewall again at the end of the
service session.
Alternative procedure for deactivating the
Firewall
The remote diagnosis via the TeleService PC software
uses the
LSV2
service and this service must therefore be
permitted in the firewall settings.
The following deviations from the firewall default settings
are required:
Set the method to
Permit some
for the
LSV2
service
Enter the name of the service computer in the
Computer
column
The access security is ensured through the network
settings. The network security is the responsibility of
the machine tool builder or the respective network
administrator.
Automatic installation of a session certificate
With an NC software installation a temporary certificate is
automatically installed on the control. An installation, also in the
form of an update, may only be carried out by a service technician
from the machine tool builder.
390
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022