HEIDENHAIN TNC 620, Руководство пользователя

Страница: 337 / 521

Pallets | Batch Process Manager (option 154)
Editing a job list
You can edit a job list in the
Programming
,
Program run, single
block
, and
Program run, full sequence
operating modes.
Operating notes:
If a job list is selected in the
Program run, single
block
or
Program run, full sequence
operating
mode, it is not possible to edit the job list in the
Programming
operating mode.
The possibilities of changing a job list during
machining are limited, because the control defines a
protected area.
NC programs in the protected area are shown in light
gray.
To edit a line in the job list in
Batch Process Manager
:
Open the desired job list
Press the
EDIT
soft key
Place the cursor on the desired line (e.g.,
Pallet
)
The control displays the selected line in blue.
The control displays the editable entries on the
right-hand side.
Press the
CHANGE WINDOW
soft key if required
The control switches the active window.
The following entries can be changed:
Name
Datum table
Preset
Locked
Machinable
Confirm the edited entries by pressing the
ENT
key.
The control adopts the changes.
Press the
EDIT
soft key
8
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
337