GSK GSK980TDc, Руководство пользователя

Страница: 441 / 470

Chapter 4 Machine Debugging methods and Modes
419
Ⅲ
Connection
The CW clamping duration setting should be proper, it should be neither longer nor shorter,
longer delay may damage the motor, shorter delay may cause the tool post not to be completely
clamped. The method to check the tool post clamping is: approach the dial-indicator to the tool post,
turn the tool post manually, and the pointer floating of the dial-indicator should not be over 0.01mm.
The BIT7(TL-) and BIT6(TL+) of diagnosis message DGN.005 are used to check the validity of
tool post CCW/CW output signal.
The BIT0 ～ BIT3 (T01 ～ T04) of diagnosis message DGN.000 are used to check the validity of
tool number T01
～
T04 signal.
During debugging, every tool, max. tools change should be performed to check the correctness
of the tool change, time parameter setting.
4.9 Step/MPG Adjustment
The key on the panel can be used to select the Step mode or MPG mode, which is set by
the BIT3 of bit parameter No.001.
Bit3 =1: MPG mode active, Step mode inactive;
=0: Step mode active, MPG mode inactive;