GSK GSK980TDc, Руководство пользователя

Страница: 231 / 470

Chapter 3 Manual Operation
211
Ⅱ
Operation
Feedrate override (%) Feedrate (mm/min)
140 1764
150 1890
Note : There is about 2% error for the data in the above table.
In the manual rapid traverse, it can press key to alter the rapid override,
and there are 4 steps of F0, 25%, 50%,100% for the override.(F0 is set by data parameter No.032)
The rapid override is active under the following conditions:
(1) G00 rapid traverse (2) Rapid traverse in canned cycle
(3) Rapid traverse in G28 (4) Manual rapid traverse
3.2 Other Manual Operations
3.2.1 Spindle CCW, CW, stop control
: In Manual mode, the spindle rotates counterclockwise if pressing this key;
: In Manual mode, the spindle stops if pressing this key;
: In Manual mode, the spindle rotates clockwise if pressing this key.
3.2.2 Spindle jog
: At the moment, the spindle is in JOG state.
Functional description:
Press to enter JOG mode, and the spindle JOG function ON/OFF is executed only when
the spindle is in the state of stop.
In spindle JOG mode, by pressing key, the spindle rotates counterclockwise for jogging;
by pressing key, the spindle rotates clockwise for jogging. The jog time and speed are set by
data parameter No.108 and No.109 respectively.
When the spindle JOG rotates, is pressed to stop the spindle JOG rotation, the spindle
brake signal is not output when the JOG rotation stops.
K10.4 is set to 1, the spindle JOG is valid in any mode. In Auto or MDI mode, the spindle is in the
JOG rotation state, the program closes the spindle JOG rotation and the JOG function.
Parameter setting:
PLC parameter K104 1/0: the spindle JOG is valid in any mode/Manual, MPG, Zero return mode.
Data parameter No.108: spindle JOG time
Data parameter No.109: rotary speed in spindle JOG.