GSK GSK980TDc, Руководство пользователя

Страница: 227 / 470

Chapter 2 Power ON/OFF And Protection
207
Ⅱ
Operation
alarm, then moves reversely (for positive overtravel, move out negatively; vice versa).
2. Additional axis
The stroke range setting is the same that of the basic axis. When the additional axis is enabled,
No. 045, No.046 displays stroke range parameter of the corresponding additional axis.
2.4 Emergency Operation
During the machining, some unexpected incidents may occur because of the user programming,
operation and product fault etc. So the GSK980TDc should be stopped immediately for these
incidents. This section mainly describes the resolutions that the system is capable of under the
emergency situation. Please see the relative explanation on these resolutions under the emergency
by machine manufacturer.
2.4.1 Reset
Press key to reset GSK980TDc system when there are abnormal output and axis
operations:
1 All axes motion stops;
2 M, S function output is inactive (the parameter sets whether the system automatically cuts off
signals of spindle rotation, lubricating, cooling by pressing key, defined by PLC
ladder);
3 Automatic run ends, modal function and state remain.
2.4.2 Emergency stop
During machine running, if the emergency button is pressed under the dangerous or emergent
situation (external SP signal active), the CNC system enters into emergency status and the machine
movement is stopped immediately. All the outputs such as the spindle running, cooling are cut off. If
the emergency button is released, the emergency alarm is cancelled and the CNC resets. Its circuit
wiring is shown in
Section 2.3.1 of the Chapter.
Note 1: Ensure the fault is eliminated before the emergency alarm is cancelled.
Note 2: Pressing down the Emergency button prior to power on or off may alleviate the electric shock to the
machine system.
Note 3: Re-perform the machine zero return to get the correct position coordinate after the emergency alarm
is cancelled (machine zero return is forbidden if there is no machine zero on the machine.).
Note 4: Only Bit3 of the bit parameter No.172 is set to 0, is the external emergency stop active.
2.4.3 Feed hold
Press key during the machine running to make the running pause. However, in threading
cutting, tapping cycle state, the function cannot stop the running immediately.
2.4.4 Power-off
Under the dangerous or emergency situations during the machine running, the machine power