GE H48651KR, Руководство по обслуживанию

Страница: 129 / 516

GE V
OLUSON
i / V
OLUSON
e
D
IRECTION
KTI106052, R
EVISION
10 S
ERVICE
M
ANUAL
Chapter 3 - Setup Instructions 3-59
3-5-13-4 Voluson i / Voluson e mounted on Voluson Station
NOTE: For instructions see: Section 3-5-3-9 "Mounting large Peripherals (e.g., VCR)" on page 3-42 .
The VCR must be powered from the Voluson Station itself, via one of the isolated peripheral power
cables provided on the Voluson Station. The video signal is received through a VGA-to-video converter,
and this must also be powered through one of the peripheral power outlets available on the
Voluson Station.
1.) Connect one end of the Audio-cable to AUDIO OUT located on the Image Resizer of the Voluson
Station.
2.) Connect the other end of the Audio-cable to AUDIO IN at the rear of the VCR.
3.) Connect one end of the S-Video cable to S-VIDEO OUT located on the Image Resizer of the
Voluson Station.
4.) Connect the other end of the S-Video cable to S-VIDEO IN at the rear of the VCR.
5.) If not already done, set the switch to the correct positions (PAL or NTSC).
6.) When all power and signal cables are connected to the system, VCR, and video converter, proceed
as follows (
in the order stated
):
a.) Press the power ON switch on the VCR.
b.) Turn ON power to the Voluson i / Voluson e system.
c.) Press the Circuit breaker on the Voluson Station.
NOTE: Please make sure, that the VGA Port is enabled.
Figure 3-73 Connection Scheme
Power Socket
from Voluson Station