GAC Trumpchi GS4, Руководство пользователя

Страница: 278 / 287

6. Accident Handling
Rear towing
OMA28-0152
Screw the rear towing ring into the thread hole
on the right of rear bumper. You can see this
thread hole when you pry the cover plate of
front bumper. Use the socket wrench for wheel
bolts or other suitable tools to tighten the tow-
ing ring.
Detailed steps are shown below:
- Take the towing ring and wheel nut wrench
out of the tool kit case in the trunk.
- Pry the cover plate by using screwdriver
and hang it on the car.
- Screw the towing ring into the thread
hole on the rear of front bumper in arrow
direction and tighten it.
- Insert the demounting wrench for wheel
bolts into the towing ring until it reaches
to limit position.
Warning
• Unless you have the experience, do
not tow other vehicle to avoid acci-
dents.
• Make sure the towing ring is se -
cured in the threaded hole firmly.
Failure to do so can cause the tow -
ing ring comes off the threaded
hole.
If you finish the towing, remove the towing ring
in the reverse order of installation, and place
the cover plate in position.
Note
• Make sure the towing ring is in the
vehicle.
• The driver in the towed vehicle must
turn on the hazard warning lights
and follow the local laws and regu-
lations.
• Start the vehicle gradually until the
tow rope strains, and then acceler-
ate gradually.
• To start the vehicle, engage the
clutch gently and gradually (manual
transmission), and press the ac-
celerator pedal gradually (automatic
transmission)
• Remember that both the brake
booster and the steering booster
of the towed vehicle are disabled!
Normally, press the brake pedal in
advance and press it slightly fre-
quently.
A28 V5_2016-04-11.indd 357 2016/7/11 16:05:26
272