Fujitsu Siemens Computers PRIMERGY BX, Описание

Страница: 373 / 674

Management Commands Command Reference
Lan Switch and Router Blade
373
all -
All interfaces.
no -
disable IPv6.
Default Setting
Enabled
Command Mode
Global Config
7.5.2 Serial Interface Commands
7.5.2.1 show line console
This command displays serial communication settings for the switch.
Syntax
show line console
Default Setting
None
Command Mode
Privileged Exec
Display Message
Serial Port Login Timeout (minutes):
Specifies the time, in minutes, of inactivity on a
Serial port connection, after which the Switch will close the connection. Any numeric value
between 0 and 160 is allowed, the factory default is 5. A value of 0 disables the timeout.
Baud Rate:
The default baud rate at which the serial port will try to connect. The available
values are 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200 bauds.
Character Size:
The number of bits in a character. The number of bits is always 8.
Flow Control:
Whether Hardware Flow-Control is enabled or disabled. Hardware Flow
Control is always disabled.
Stop Bits:
The number of Stop bits per character. The number of Stop bits is always 1.
Parity:
The Parity Method used on the Serial Port. The Parity Method is always None.
Password Threshold:
When the logon attempt threshold is reached on the console port, the
system interface becomes silent for a specified amount of time before allowing the next
logon attempt. (Use the silent time command to set this interval.) When this threshold is
reached for Telnet, the Telnet logon interface closes.
Silent Time (sec):
Use this command to set the amount of time the management console is
inaccessible after the number of unsuccessful logon attempts exceeds the threshold set by
the password threshold command.