Fujitsu Siemens Computers PRIMERGY BX, Описание

Страница: 171 / 674

Main Menu Web-Based Management Interface
Lan Switch and Router Blade
171
network .
*NOTE: once OSPF is initialized on the router, it will remain initialized until the
router is reset.
OSPF Area ID
- Enter the 32 bit integer in dotted decimal format that uniquely identifies
the OSPF area to which the selected router interface connects. If you assign an Area ID
which does not exist, the area will be created with default values.
Router Priority
- Enter the OSPF priority for the selected interface. The priority of an
interface is specified as an integer from 0 to 255. The default is 1, which is the highest
router priority. A value of '0' indicates that the router is not eligible to become the
designated router on this network
Retransmit Interval
- Enter the OSPF retransmit interval for the specified interface. This
is the number of seconds between link-state advertisements for adjacencies belonging to
this router interface. This value is also used when retransmitting database descriptions
and link-state request packets. Valid values range from 1 to 3600 seconds (1 hour). The
default is 5 seconds.
Hello Interval
- Enter the OSPF hello interval for the specified interface in seconds. This
parameter must be the same for all routers attached to a network. Valid values range
from 1 to 65,535. The default is 10 seconds.
Dead Interval
- Enter the OSPF dead interval for the specified interface in seconds. This
specifies how long a router will wait to see a neighbor router's Hello packets before
declaring that the router is down. This parameter must be the same for all routers
attached to a network. This value should a multiple of the Hello Interval (e.g. 4). Valid
values range from 1 to 2147483647. The default is 40.
Iftransit Delay Interval
- Enter the OSPF Transit Delay for the specified interface. This
specifies the estimated number of seconds it takes to transmit a link state update packet
over the selected interface. Valid values range from 1 to 3600 seconds (1 hour). The
default value is 1 second.
MTU Ignore
- Disables OSPF MTU mismatch detection on receiving packets. Default
value is Disable.
Authentication Type
- You may select an authentication type other than none by clicking
on the 'Configure' button. You will then see a new screen, where you can select the
authentication type from the pulldown menu. The choices are:
ƒ
None
- This is the initial interface state. If you select this option from the pulldown
menu on the second screen you will be returned to the first screen and no
authentication protocols will be run.
ƒ
Simple
- If you select 'Simple' you will be prompted to enter an authentication key.
This key will be included, in the clear, in the OSPF header of all packets sent on the
network. All routers on the network must be configured with the same key.
ƒ
Encrypt
- If you select 'Encrypt' you will be prompted to enter both an authentication
key and an authentication ID. Encryption uses the MD5 Message-Digest algorithm. All
routers on the network must be configured with the same key and ID.
Authentication Key
- Enter the OSPF Authentication Key for the specified interface. If
you do not choose to use authentication you will not be prompted to enter a key. If you