Fuji Electric ALPHA7, Руководство пользователя

Страница: 356 / 662

CHAPTER 6 KEYPAD
Display
6-3
6
4
6.1.2 Key

To display five or more digits, switch the display alternately between the four higher order digits and
four lower order digits. (5-digit data with no symbol is displayed without switching the displayed
digits.)

To display nine or more digits, switch the display alternately between the four higher order digits,
four middle order digits, and four lower order digits. (9-digit data with no symbol is displayed by
switching between the five higher order digits and five lower order digits.)
6.1.3 Flashing Display
There are times when the keypad flashes.
The flashing status and meanings are shown in the following table.
Flashing interval Duration Status Recovery method
1 second cycle Continuous Alarm occurring
Restart the servo amplifier or reset
the alarm.
0.5 second cycle 3 seconds Setting parameters -
Once every 2
seconds
Continuous In sequence test mode
Restart the servo amplifier or,
change PA2_89 to 0 and then restart.
Twice every 2
seconds
Continuous Restart notification
*
Restart the servo amplifier.
*
: If valid parameters changed after restarting the servo amplifier.
[

]
The sub mode is selected.
The value decreases by one (-1).
[

]
The sub mode is selected.
The value increases by one (+1).
[MODE/ESC]

The mode is switched (MODE).
 The mode is deselected (ESC).
[SET/SHIFT]

The cursor digit shifts to the right
(SHIFT).

The mode or value settles (SET).

Press and hold for at least one
second to settle.