Fuji Electric ALPHA7, Руководство пользователя

Страница: 104 / 662

CHAPTER 2 WIRING
Description of I/O Signals
2-57
2
 Parameter setting
To assign position control to a sequence input terminal, specify the corresponding value ("37") to
the input terminal function setting parameter. For command pulse ratio 1, specify ("27"), while
specify ("28") for command pulse ratio 2.
This signal is handled to be always turned off if it is not assigned to the sequence input signal.
[Example] To conduct operation with a command pulse input
Operation with a command pulse input is enabled while command pulse ratio 1 or
command pulse ratio 2 remains turned on after the position control signal is turned
on.
 Relevant description
(1) PA1_6: numerator 0 of electronic gear /PA1_7: denominator of electronic gear
In the factory shipment state, each pulse of a pulse input turns the servomotor by 16 encoder
pulses.
With an incremental encoder, each revolution of the motor shaft corresponds to 16777216 pulses
(24 bits).
Use the electronic gear to change the rotation amount of the servomotor corresponding to each
pulse of the pulse input.
(2) PA2_54: command pulse ratio 1/PA2_55: command pulse ratio 2
Numerator 0 of electronic gear and denominator of electronic gear convert the traveling amount of
the mechanical system per each pulse of the pulse input into a unit amount.
Or the multiplication of the traveling amount of the mechanical system can be changed with
command pulse ratio 1 or command pulse ratio 2.
Pulse
Position control (37)
Command pulse ratio 1 (27)
APS30
PWR
ALM
ＳＸ
SCPU3
2
LOADER
RUN
TERM
SLV
STOP
CPU
No.
ONL
ERR
RUN
ALM
BAT
ONL 0 1 2 3 4 5 6 7
ERR 8 9 101112131415
ONL CH1
ERR CH2
EMG +OT -OT
20
1
B/A
HP2
ONL
ERR
PE1
PH
PL
DA
CH
No.
SCPU3
2
LOADER
RUN
TERM
SLV
STOP
CPU
No.
ONL
ERR
RUN
ALM
BAT
ONL 0 1 2 3 4 5 6 7
ERR 8 9 101112131415