Extreme Networks ExtremeWare XOS 11.0, Справочник по командам

Страница: 562 / 970

562 ExtremeWare XOS 11.0 Command Reference Guide
ESRP Commands
configure esrp ports mode
configure esrp ports <ports> mode [host | normal]
Description
Configures the ESRP port mode for ESRP host attach.
Syntax Description
Default
Normal.
Usage Guidelines
Ports configured as normal ports do not accept or transmit Layer 2 or Layer 3 traffic when the local
ESRP device is a slave.
Ports configured as host ports allow the network to continue operation independent of ESRP status. The
command sets the port to forward, allowing those ports directly attached to the slave’s hosts to
communicate with other hosts that are connected to the master. If you use load sharing with the ESRP
HA feature, configure the load-sharing group first and then enable Host Attach on the group.
An L2 connection for VLANs between ESRP switches is required.
Example
The following command configures ports 1 through 5 on slot 3 as host ports:
configure esrp port 3:1-3:5 mode host
History
This command was first available in ExtremeWare XOS 11.0.
ports Specifies the list of ports that should be configured. May be in the form 2:*,
2:5, 2:6-2:8.
host Specifies that the ports should be configured as host ports.
normal Specifies that the ports should be configured as normal ports.