Extreme Networks ExtremeWare XOS 11.0, Справочник по командам

Страница: 174 / 970

174 ExtremeWare XOS 11.0 Command Reference Guide
Commands for Managing the Switch
tftp
tftp [<host_name> | <ip_address>] {-v <vr_name>} [-g | -p] [{-l
<local_file>} {-r <remote_file>} | {-r <remote_file>} {-l <local_file>}]
Description
Allows you to TFTP from the current command line interface session to a TFTP server.
Syntax Description
Default
If you do not specify a virtual router, VR-Mgmt is used.
Usage Guidelines
NetASCII and mail file type formats are not supported.
Extreme Networks recommends using a TFTP server that supports blocksize negotiation (as described
in RFC 2348), to enable faster file downloads and larger file downloads.
Use TFTP to download a previously saved configuration file or policy file from the TFTP server to the
switch. When you download a file, this command does not automatically apply it to the switch. You
must specify that the downloaded file be applied to the switch. For example, if you download a
configuration file, issue the
use configuration
command to apply the saved configuration on the next
reboot. You must use the
reboot
command to activate the new configuration. If you download a policy
file, use the
refresh policy
command to reprocess the text file and update the policy database.
To upgrade the BootROM, use the
download bootrom
command. This command utilizes TFTP to
transfer the BootROM image file from your TFTP server to the switch. Only upgrade the BootROM
when asked to do so by an Extreme Networks technical representative. For more information about this
command, see “download bootrom” on page 928.
To upgrade the image, use the
download image
command. This command utilizes TFTP to transfer the
software image file from your TFTP server to the switch. For more information about this command, see
“download image” on page 929.
Up to eight active TFTP sessions can run on the switch concurrently.
You must configure DNS in order to use the
host_name
option.
The
vr_name
option specifies the name of the virtual router. The valid virtual router names at system
boot-up are VR-Mgmt, VR-Control, and VR-Default. You can also create and configure your own virtual
host_name Specifies the name of the remote host.
ip_address Specifies the IP address of the TFTP server.
vr_name Specifies the name of the virtual router.
-g Gets the specified file from the TFTP server and copies it to the local host.
-p Puts the specified file from the local host and copies it to the TFTP server.
local_file Specifies the name of the file (configuration file, policy file) on the local host.
remote_file Specifies the name of the file on the remote host.