Extreme Networks ExtremeWare XOS 11.0, Справочник по командам

Страница: 307 / 970

unconfigure qosprofile ports
ExtremeWare XOS 11.0 Command Reference Guide 307
unconfigure qosprofile ports
unconfigure qosprofile {ingress | egress} ports [<port_list>|all]
Description
Returns the ingress rate shaping parameters, which is an ingress QoS profile, or the egressing QoS
values to default values.
Syntax Description
Default
Ingress QoS is disabled by default.
• Minimum bandwidth—0%
• Maximum bandwidth—100%
• Minimum committed and peak rates—1 Kbps
• Maximum committed and peak rates—varies by I/O module:
— 1G I/O module—1,000 Mbps
— 10G I/O module—10,000 Mbps
• Ingress priority—By default, each qosprofile is assigned a different priority level, which varies by
I/O module:
— 1G I/O module:
• IQP1 - 1 Low
• IQP2 - 1, LowHi
— 10G I/O module:
• IQP1 - 1, Low
• IQP2 - 2, LowHi
ingress Specifies all ingress QoS profiles for specified ports. The default ingress
values are as follows:
• for 1G I/O modules—IQP1 and IQP2
• for 10G I/O modules—IQP1 to IQP8
If you do not specify ingress or egress, the command returns all egress QoS
values to default.
egress Specifies an egress QoS profile for specified ports. The default egress values
are as follows:
• for 1G I/O modules—IQP1 and IQP2
• for 10G I/O modules—IQP1 to IQP8
If you do not specify ingress or egress, the command returns all egress QoS
values to default
port_list Specifies a list of slots and ports to which the parameters apply. May specify
in the form 3-5, 2:5, 2:6-2:8.
all Specifies that this applies to all ports on the device.