Extreme Networks ExtremeWare XOS 11.0, Справочник по командам

Страница: 528 / 970

528 ExtremeWare XOS 11.0 Command Reference Guide
STP Commands
show stpd
show stpd {<stpd_name> | detail}
Description
Displays STPD settings on the switch.
Syntax Description
Default
N/A.
Usage Guidelines
The command displays the following STPD information:
• STPD name
• STPD state
• STPD mode of operation
• Autobind mode
• Rapid Root Failover
• Tag
• Ports
• Active VLANs
• Bridge Priority
• Bridge ID
• Designated root
• STPD configuration information
You can create, configure, and enable one or more STPDs and use the
show stpd
command to display
STP configurations. Use the
create stpd <stpd_name>
command to create an STPD. Use the
enable
stpd {<stpd_name>}
command to enable an STPD. If you have considerable knowledge and
experience with STP, you can configure the STPD using the
configure stpd
commands. However, the
default STP parameters are adequate for most networks.
If your STPD has the same name as another component, for example a VLAN, Extreme Networks
recommends that you specify the identifying keyword as well as the name. If you do not specify the
stpd
keyword, an error message similar to the following is displayed:
%% Ambiguous command: "show Test"
In this example, to view the settings of the STPD Test , enter
show stpd Test
.
If your STPD has a name unique only to that STPD, the keyword
stpd
is optional.
stpd_name Specifies an STPD on the switch.
detail Specifies that STPD settings should be shown for each STPD.