Extreme Networks ExtremeWare XOS 11.0, Справочник по командам

Страница: 320 / 970

320 ExtremeWare XOS 11.0 Command Reference Guide
Commands for Status Monitoring and Statistics
configure log target filter
configure log target [console | memory-buffer | primary-msm | backup-msm |
nvram | session | syslog [all | <ipaddress> {vr <vr_name>} [local0 ...
local7]]] filter <filter-name> {severity <severity> {only}}
Description
Associates a filter to a target.
Syntax Description
Default
If severity is not specified, the severity level for the target is left unchanged. If a virtual router is not
specified, VR-Mgmt is used.
Usage Guidelines
This command associates the specified filter and severity with the specified target. A filter limits
messages sent to a target.
Although each target can be configured with its own filter, by default, all targets are associated with the
built-in filter,
DefaultFilter . Each target can also be configured with its own severity level. This provides
the ability to associate multiple targets with the same filter, while having a configurable severity level
for each target.
A message is sent to a target if the target has been enabled, the message passes the associated filter, the
message is at least as severe as the configured severity level, and the message output matches the
regular expression specified. By default, the memory buffer, NVRAM, primary MSM, and backup MSM
targets are enabled. For other targets, use the command
enable log target
on page 354. Table 10
describes the default characteristics of each type of target.
target Specifies the device to send the log entries.
console Specifies the console display.
memory-buffer Specifies the switch memory buffer.
nvram Specifies the switch NVRAM.
primary-msm Specifies the primary MSM.
backup-msm Specifies the backup MSM.
session Specifies the current session (including console display).
vr_name Specifies the virtual router that can reach the server IP address.
syslog Specifies a syslog remote server.
all Specifies all of the syslog remote servers.
ipaddress Specifies the syslog IP address.
local0 ... local7 Specifies the local syslog facility.
filter-name Specifies the filter to associate with the target.
severity Specifies the minimum severity level to send (if the keyword only is omitted).
only Specifies that only the specified severity level is to be sent.