Evidence Cross-8/HPoE-10G, Руководство пользователя

Страница: 69 / 321

Web Interface
To configure the Loop Protection parameters in the web interface:
1. Click Port Management, Loop Protection and Configuration.
2. Evoke to select enable or disable the port loop Protection.
3. Click the apply to save the setting.
4. If you want to cancel the setting then you need to click the Reset button. It will revert to
previously saved values.
Figure 3-6.1: The Loop Protection Configuration
Parameter description :
Global Configuration

Enable Loop Protection :
Controls whether loop protections is enabled (as a whole).

Transmission Time :
The interval between each loop protection PDU sent on each port. Valid values are 1 to 10
seconds.

Shutdown Time :
The period (in seconds) for which a port will be kept disabled in the event of a loop is
detected (and the port action shuts down the port). Valid values are 10 to 604800 seconds
(7 days).
Port Configuration

Port :
The switch port number of the port.

Enable :
Controls whether loop protection is enabled on this switch port

Action:
Configures the action performed when a loop is detected on a port. Valid values are Shutdown Port,
Shutdown Port and Log or Log Only.

Tx Mode :