Evidence Cross-8/HPoE-10G, Руководство пользователя

Страница: 35 / 321

The interface name to which the configuration applies.

Capabilities :
When checked the switch's capabilities is included in LLDP-MED information transmitted.

Policies :
When checked the configured policies for the interface is included in LLDP-
MED information transmitted.

Location :
When checked the configured location information for the switch is included in LLDP-
MED information transmitted.

PoE :
When checked the configured PoE (Power Over Ethernet) information for the interface is
included in
LLDP-MED information transmitted.

Device Type :
Any LLDP-MED Device is operating as a specific type of LLDP-MED Device, which may be
either a Network Connectivity Device or a specific Class of Endpoint Device, as defined
below.
A Network Connectivity Device is a LLDP-MED Device that provides access to the IEEE 802
based LAN infrastructure for LLDP-MED Endpoint Devices
An LLDP-MED Network Connectivity Device is a LAN access device based on any of the
following technologies :
1. LAN Switch/Router
2. IEEE 802.1 Bridge
3. IEEE 802.3 Repeater (included for historical reasons)
4. IEEE 802.11 Wireless Access Point
5. Any device that supports the IEEE 802.1AB and MED extensions that can relay IEEE 802
frames via any method.
An Endpoint Device a LLDP-MED Device that sits at the network edge and provides some
aspect of IP communications service, based on IEEE 802 LAN technology.
The main difference between a Network Connectivity Device and an Endpoint Device is that
only an Endpoint Device can start the LLDP-MED information exchange.
Even though a switch always should be a Network ConnectivityDevice, it is possible to
configure it to act as an Endpoint Device, and thereby start the LLDP-MED information
exchange (In the case where two Network Connectivity Devices are connected together)
Coordinates Location

Latitude :
Latitude SHOULD be normalized to within 0-90 degrees with a maximum of 4 digits.
It is possible to specify the direction to either North of the equator or South of the equator.

Longitude :
Longitude SHOULD be normalized to within 0-180 degrees with a maximum of 5 digits.
It is possible to specify the direction to either East of the prime meridian or West of the
prime meridian.

Altitude :
Altitude SHOULD be normalized to within -32767 to 32767 with a maximum of 4 digits.