Evidence Cross-8/HPoE-10G, Руководство пользователя

Страница: 175 / 321

Be Caution: MVR source ports are not recommended to be overlapped with management
VLAN ports.

MVR Name :
MVR Name is an optional attribute to indicate the name of the specific MVR VLAN.
Maximum length of the MVR VLAN Name string is 32. MVR VLAN Name can only contain
alphabets or numbers. MVR VLAN name can be edited for the existing MVR VLAN entries
or it can be added to the new entries.

IGMP Address :
Define the IPv4 address as source address used in IP header for IGMP control frames.
The default IGMP address is not set (0.0.0.0).
When the IGMP address is not set, system uses IPv4 management address of the IP
interface associated with this VLAN.
When the IPv4 management address is not set, system uses the first available IPv4
management address.
Otherwise, system uses a pre-defined value. By default, this value will be 192.0.2.1.

Mode :
Specify the MVR mode of operation. In Dynamic mode, MVR allows dynamic MVR
membership reports on source ports. In Compatible mode, MVR membership reports are
forbidden on source ports. The default is Dynamic mode.

Tagging :
Specify whether the traversed IGMP/MLD control frames will be sent as Untagged or
Tagged with MVR VID. The default is tagged.

Priority :
Specify how the traversed IGMP/MLD control frames will be sent in prioritized manner. The
default Priority is 0.

LLQI :
Define the maximum time to wait for IGMP/MLD report memberships on a receiver port
before removing the port from multicast group membership. The value is in units of tenths
of a seconds. The range is from 0 to 31744. The default LLQI is 5 tenths or one-half second.

Interface Channel Profile :
When the MVR VLAN is created, select the profile to expand the corresponding multicast
channel settings for the specific MVR VLAN. The file established on
Filtering Profile Table.

Port :
The logical port for the settings.

Port Role :
Configure an MVR port of the designated MVR VLAN as one of the following roles.
Inactive: The designated port does not participate MVR operations.
Source: Configure uplink ports that receive and send multicast data as source ports.
Subscribers cannot be directly connected to source ports.
Receiver: Configure a port as a receiver port if it is a subscriber port and should only
receive multicast data. It does not receive data unless it becomes a member of the
multicast group by issuing IGMP/MLD messages.
Be Caution: MVR source ports are not recommended to be overlapped with management
VLAN ports. Select the port role by clicking the Role symbol to switch the setting. I