OPERATOR’S
MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page
14-5
November 19, 2009
FUEL REMAINING AT ANY WAYPOINT
With the desired waypoint identifier in the scratchpad (keyed in, or copied from any other page), move it into the
FIX field by pressing LSK 4R in the RTE x FUEL 1/2 page.
Fuel remaining at the selected waypoint is calculated based on the displayed fuel quantity (excluding reserve), fuel
flow rate and ground speed.
NOTE: By default the last waypoint of the active route is displayed. If an airport destination is entered in the
RTE page, then that destination waypoint is used to decide if the alert message “NOT ENOUGH FUEL”
will be triggered or not. The message is triggered if the fuel required to fly the along track distance from
the present position to the destination airport coordinates (excluding the missed approach procedure) is
not sufficient.
SIMULATION FUNCTIONS
The CMA-9000 FMS provides Fly Away and OEI Cruise simulation functions, which allow the pilot to determine
in advance the consequences of the loss of an engine in hover or cruise operation. The CMA-9000 FMS also
provides a RTE x LEGS page simulation that allows the pilot to perform simulated ETA/EFA computations on
the inactive route.
There is no consequence of these calculations on the active flight data.
Entry of the performance charts required for the Fly Away and OEI Cruise functions is done via the data load
unit. The name and date identification of the loaded tables are displayed on the IDENT 2/2 page.
1 R
2 R
3 R
4 R
5 R
6 R
FMS1 IDENT 2/2
M A G V A R M O D E L
2 0 0 0 ( D E F )
O E I M O D E L
( D E F )
D A T E
S P U M A M K I I + N O V 0 6 / 0 1
<
SETUP POS INIT
>
1 L
2 L
3 L
4 L
5 L
6 L
This page is printed under user's responsibility
and must not be retained for reference