Endress+Hauser iTEMP TMT85, Руководство по эксплуатации

Страница: 41 / 100

iTEMP TMT85 Diagnostics and troubleshooting
Hauser 41
Category No. Status messages
• ACTUAL_STAT
US_NUMBER
in the
'Advanced
Diagnostics'
Transducer
Block
• Local display
Error messages in the
relevant Sensor
Transducer Block Sensor
Transducer Block
measured value
status (default) Cause of error /
remedy Output variables
affected
F- 437 Device status
message (FF):
Configuration
incorrect
F-437
Local display:
F437 BLOCK_ERR = Other |
Block configuration
error QUALITY = BAD Cause of error:
Incorrect
configuration in
Transducer Blocks
"Sensor 1 and 2".
The reason for the
configuration error
is displayed in the
"BLOCK_ERR_DES
C1" parameter.
Remedy:
Check the
configuration of
the sensor types
used, the units and
the settings of PV1
and/or PV2. SV1, SV2, PV1,
PV2, DT
Transducer_Error =
Configuration error SUBSTATUS =
Device failure
9.2.2 Category M diagnostics messages
Category No. Status messages
• ACTUAL_STAT
US_NUMBER
in the
'Advanced
Diagnostics'
Transducer
Block
• Local display
Error messages in the
relevant Sensor
Transducer Block Sensor
Transducer Block
measured value
status (default) Cause of error /
remedy Output variables
affected
M- 042 Device status
message (FF):
Corrosion
M-042
Local display:
M042 ↔
Measured value BLOCK_ERR = Other QUALITY =
UNCERTAIN
(configurable) Cause of error:
Corrosion detected
on the sensor
terminals.
Remedy:
Check wiring and
replace if
necessary. SV1, SV2, also
PV1, PV2
depending on the
configuration
Transducer_Error = No
error SUBSTATUS =
Sensor conversion
not accurate
M- 101 Device status
message (FF):
Sensor value too
low
M-101
Local display:
M101 ↔
Measured value BLOCK_ERR = Other QUALITY =
UNCERTAIN Cause of error:
Physical
measuring range
undershot.
Remedy:
Select suitable
sensor type. SV1, SV2, also
PV1, PV2
depending on the
configuration
Transducer_Error = No
error SUBSTATUS =
Sensor conversion
not accurate
M- 102 Device status
message (FF):
Sensor value too
high
M-102
Local display:
M102 ↔
Measured value BLOCK_ERR = Other QUALITY =
UNCERTAIN Cause of error:
Physical
measuring range
overshot.
Remedy:
Select suitable
sensor type. SV1, SV2, also
PV1, PV2
depending on the
configuration
Transducer_Error = No
error SUBSTATUS =
Sensor conversion
not accurate