Endress+Hauser iTEMP TMT85, Руководство по эксплуатации

Страница: 32 / 100

Commissioning iTEMP TMT85
32 Hauser
• The files required for commissioning and network configuration can be obtained as
described on →  27.
• In the case of the FOUNDATION Fieldbus TM , the device is identified in the host or
configuration system by means of the device ID (DEVICE_ID). The DEVICE_ID is a
combination of the manufacturer ID, device type and device serial number. It is unique
and can never be assigned twice. The structure of the DEVICE_ID can be broken down as
follows:
DEVICE_ID = 452B4810CE-XXXXXXXXXXX
452B48 = Hauser
10CE = TMT85
XXXXXXXXXXX = Device serial number (11-digit)
• For a quick and reliable head transmitter configuration, a wide range of configuration
wizards are available to guide the user through the configuration of the most important
parameters of the Transducer Blocks. For this, refer to the operating manual of your
operating and configuration software.
The following wizards are available:
Configuration wizards
Name Block Description
Quick Setup Sensor Transducer Configuration of the sensor input with the data
relevant to the sensor.
Quick Setup Display Transducer Menu-guided configuration of the display unit.
Set to OOS mode Resource, Sensor
Transducer, Display
Transducer, AdvDiagnostic
Transducer, AI, PID and
ISEL Sets the individual block to the "Out Of Service"
mode
Set to auto mode Resource, Sensor
Transducer, Display
Transducer, AdvDiagnostic
Transducer, AI, PID and
ISEL Sets the individual block to the "Auto" mode
Restart Resource Restarts the device with different options as to
which particular parameters should be reset to the
factory settings.
Sensor drift monitoring
configuration AdvDiagnostic Transducer Settings for drift or differential monitoring with 2
connected sensors.
Calc.wizard for 2-wire
compensation value Sensor Transducer Calculation of the conductor resistance for 2-wire
compensation.
Set all TRD to OOS mode All Transducer Blocks Sets all Transducer Blocks simultaneously to the
"Out Of Service" mode
Set all TRD to auto mode All Transducer Blocks Sets all Transducer Blocks simultaneously to the
"Auto" mode
Show recommended action Resource Displays the recommended action for the
diagnostic event currently pending.
Calibration wizards
User sensor trim
configuration Sensor Transducer Menu guidance for linear scaling ( slope)
for adapting the measuring point to the process
(→  66).
Factory trim settings Sensor Transducer Resets scaling to the "factory standard trim"
(→  66).
RTD-Platin configuration
(Call.-Van Dusen) Sensor Transducer Entry of Callendar-Van-Dusen coefficients.
RTD-Copper configuration Sensor Transducer Entry of coefficients for nickel polynomial.
RTD-Nickel configuration Sensor Transducer Entry of coefficients for copper polynomial.