Eliet DZC600, Руководство пользователя

Страница: 68 / 77

68
English
12.Storing the machine
When storing the machine for an extended period, we recommend that you follow the steps
below:
• Clean the entire machine thoroughly. (Read §”9.7 Cleaning the machine” on page 35).
• Ensure that the seed container has been fully emptied before storing the machine. Any
remaining seeds in the seed container or seed duct may germinate and block the seed
flow. The model with a seed collector vessel has a small rotating device, which enables
you to rotate the seed distributor manually. This way you can completely empty the seed
container.
• Carry out a full service (see § “11.2 Maintenance schedule” on page 47).
• Check all nuts and bolts and tighten them where necessary. Most bolts require the use of
two spanners of 10, 13, 14, 17 or 19 mm and wrenches 4, 5 or 6.
• Empty the fuel tank either by running the engine until the machine runs out of fuel, or
by using a siphon to pump the petrol back into the jerry can (read the safety instructions
under §”9.4
Preparing the machine” on page 24).
• Remove the spark plug (see § “11.3.5 Checking and/or changing the spark
plug” on page 52). Spray a little penetrating oil on the basis of MoS2 into the cylinder
cavity. Pull the starter cord until the piston is in its uppermost position. Replace the spark
plug.
• To avoid rust on the machine touch up all chipped areas or treat them with anti-rust
grease. Original paints/enamels in the appropriate colours are available from your ELIET
dealer.
• Store the machine in a dry storage area, away from possible rain. If necessary, cover it with
canvas.
• If the machine is stored outdoors, it must be properly covered with canvas. Avoid direct
precipitation on the machine. ELIET highly recommends a sheltered storage place.