Eliet DZC600, Руководство пользователя

Страница: 36 / 77

36
English
The following points require special attention:
• Always remove the seed from the seed container after an overseeding session (use a vacuum
cleaner to remove the seed from the bottom parts). The model with a seed collector vessel
has a lever to manually screw the jack into the seeding compartment. This also enables you to
remove any remaining seed from the collector vessel (item number MA 028 001 001).
• Also check that the seed funnels are completely clear.
• The engine should be clear of dust and dirt. Particularly the cooling fins, the exhaust and the
area around the exhaust must be clear. The area around the fuel cap must be kept clean to
avoid dirt entering the fuel tank. Blow away any dirt that might block the throttle control.
• Check and clean the air filter on a regular basis.
• Check and lubricate the chain drives.
• The bushings must be cleared from sand and dirt, as this sticks to the lubricant. Afterwards,
new lubricating grease needs to be applied (see § “11.2 Maintenance schedule” on
page 47).
• Use a dry cloth or soft brush for any cleaning. To remove grease and lubricants, use MoS2-
based penetrating oil. This spray acts both as a lubricant and as a rust solvent.
• It is advised to keep transmission parts and hinges located under the large cover dust-free.
(Ideally, the chain drives are lubricated during the cleaning work: see § “11.4.2
General lubrication treatment” on page 54.)
• Check that the blades (see §”11.4.8 Checking the blades” on page 65) are not
damaged or bent.
• Clean the traction roller so the drum doesn’t get covered in dry mud.
• Use a dry cloth to remove any dirt from the chassis, especially from the safety warning
stickers.
• A steamer may be used to clean the machine. Do not spray excessive amounts of water on the
bearings, electric contacts and filler caps. Water is the number one cause of rust and this must
be avoided at all times. Allow the engine to cool down properly before spraying cold water on
it.
• A number of additional points must be observed in the cleaning procedure before long-term
storage of the machine (read more in §”12.Storing the machine” on page 68)