Eliet DZC600, Руководство пользователя

Страница: 56 / 77

56
English
ly clean.
• Make sure that all of the cleaning agent is either evaporated or wiped away.
• Apply new lubricant to the friction areas. Ensure that it covers the entire contact surface.
• ELIET recommends NOVATIO CLEARLUBE, a lubricant with an extremely long operating time,
great adhesion and resistant to high pressure. It is available in spray cans for easy application.
• Reassemble the hinge and fasten all parts.
11.4.2.2 Bearings
Bearings’ biggest enemies are an excessive load, dirt and lack of lubrication. Sowing machines
are not the best media to guarantee a long bearing life. Regular maintenance is therefore
required.
• To reach the points indicated, some protective covers and shields will have to be removed
(Read § “15.1 Removing the protective covers” on page 71 if necessary)
• The bearings have dust seals to keep the dirt out. However, the lubricant applied on the
bearing at the factory will also become old and dry. To compensate this lack of lubricant, new
lubricant must be added from outside.
• To prevent any dirt from penetrating the bearing together with the lubricant, the bearing must
be cleaned first.
• Spray NOVATIO KLEENSPRAY onto the bearing seals and joints. The liquid will soak off any
dust attached to the bearing.
• Leave the cleaning liquid to work for a few minutes.
• Remove all the dirt clinging to the bearing with a soft cloth.
• Apply a second round of spray to the bearings, particularly on the joints. The cleaner will
dissolve the grease that has dried up in the joint. This is necessary to ensure that new grease
can penetrate the joint.
• Blow compressed air into the bearing joints to enable the KLEENSPRAY to expel all the dirt.
• Wipe away all the spray and wait 10 minutes to allow any residue to evaporate.
• Now apply a new layer of lubricant. Spray good amounts of NOVATIO PTFE OIL into the joints