Edwards STP Series, Инструкция по эксплуатации

Страница: 157 / 177

STP-iXA2205 Series Turbomolecular Pump
Nov. 10 147 Issue 1-h
7
SAFETY
FUNCTIONS
7.4 WARNING function setting
The WARNING functions can be set to Enable or Disable. Set to "ENABLE" when using the
WARNING function. Set to "DISABLE" to release each WARNING function after the WARNING is
detected.
A setting value of the "Pump Run Time Over" and "Pump Overload" are adjustable. The WARNING
detection can be released by setting the value larger than pump running hours after "Pump Run Time
Over" is detected. Also, the WARNING detection can be released by powering off the pump after
"Pump Overload" is detected.
See Table 43 and Table 44 for the default setting. The setting can be changed via serial
communication, the STP-Link (optional accessory) or the display unit iDT-001 (optional accessory).
WARNING function Default setting User setting
User setting
change (threshold)
Second Damage Limit
(Failure detection)
Enable Enable Disable
Second Damage Limit
(Warning detection)
Enable Disable Disable
First Damage Limit Enable Enable Disable
Pump Run Time Over Disable Enable Enable
Pump Overload Disable Enable Enable
Imbalance Enable Enable Disable
Table 43 - Default setting of WARNING function
WARNING function
Factory setting
(threshold)
Variable range
User setting
change (threshold)
Pump Run Time Over 0 hour
0 to 100,000
hours It can be set in units of 100
hour. 0 is not counted.
Pump Overload
Motor
current
100.0 % 0 to 100.0 %
The ratio (%) to the rated
current value. Smaller
value has high possibility to
get "WARNING".
Rotational
speed
0.0 % 0 to 100.0 %
The rate (%) to the rated
speed value. Larger value
has high possibility to get
"WARNING".
Table 44 - Factory Setting and Variable Range
Note: Refer to Section 5, "Serial Communication Protocol", STP-Link, or the display unit iDT-001
Instruction Manuals for the setting methods.