Dell Precision Workstation 530, Руководство пользователя

Страница: 98 / 300

98
Removing and Installing Parts
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
NOTE: Tape drives sold by Dell come with their own operating software
and documentation. After you install a tape drive, refer to the
documentation that came with the drive for instructions on installing and
using the tape drive software.
Installing a Hard Drive
NOTE: If you are replacing a hard drive that contains data you want to keep,
be sure to back up your files before you begin this procedure.
CAUTION: Before you perform this procedure, see " Safety First—
For You and Your Computer ."
NOTICE:
Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see "
System Board
Components " or the interior service label.
1
Turn off the computer and devices, disconnect them from their
electrical outlets, and wait 10 to 20 seconds.
2
Lay the computer on its right side.
3
Open the computer cover .
4
If you are replacing a drive that is already installed in the computer,
continue with step 5 . If you are installing a new drive, go to step 7 .
5
Disconnect the DC power cable and interface cable from the back of
the drive you are replacing.
6
Remove the drive from the chassis drive bay.
a
Squeeze together the tabs at each side of the drive to disengage
the drive bracket from the chassis.
b
Slide the drive bracket upward, and remove it from the chassis (see
the following figure).