DEC DECstation 5000 Model 100 Series, Руководство по обслуживанию

Страница: 92 / 269

To remove a memory module,
1.
Turn off the workstation.
2.
Remove the system unit cover. Refer to ‘‘Removing and
Installing the System Unit Cover’’ in Chapter 2 for
directions.
3.
Loosen the two captive screws that hold the memory
module retaining bar. Then remove the bar.
4.
Grip each end of the memory module and pull the module
out of its connector. Gently rock the module back and
forth to remove it. If necessary, use the hooked end of the
retaining bar to pull up the memory module edge.
To install a memory module,
5.
Look at the slot numbers printed beside the memory
module slots and find the unused slot with the lowest
number.
6.
Align the memory module connectors above the unused slot
with the lowest number.
7.
Push the memory module connectors all the way into the
memory module slot. Gently rock the module back and
forth if necessary.
8.
Replace the retaining bar and tighten the two captive
screws.
9.
Replace the system unit cover.
10.
Turn on the system and check the power-up self-test results
to make sure the system works properly.
11.
Run the RAM board test to make sure that the new memory
module operates properly.
5–14 Basic Hardware