DEC DECstation 5000 Model 100 Series, Руководство по обслуживанию

Страница: 38 / 269

Removing and Installing a Serial Number Plate
To Remove a Serial Number Plate
1.
Turn off the system unit power.
2.
Remove the system unit cover. Refer to ‘‘Removing and
Installing the System Unit Cover’’ earlier in this chapter
for directions.
3.
Peel the tamper-proof tape off the two nuts that hold the
serial number plate.
4.
Use a crescent wrench to remove the two nuts that hold the
serial number plate.
5.
Pull the serial number plate away from the system unit.
To Install a Serial Number Plate
1.
Make sure the system unit power is off and the system unit
cover is removed.
2.
Pass the two posts on the back of the serial number plate
through the holes in the back of the system unit.
3.
Tighten the two nuts onto the posts.
4.
Apply one piece of security tape over each nut and the post
surrounding it.
Service Operations 2–9