DEC DECstation 5000 Model 100 Series, Руководство по обслуживанию

Страница: 202 / 269

ctrs Command
Use the ctrs command to display all the network counters. To
use the ctrs command, type ctrs and press Return.
A display of network counters then appears on the screen. A
typical display looks like this:
15905 : seconds since zeroed
0 : bytes received
0 : bytes sent
0 : frames received
0 : frames sent
0 : multicast bytes received
0 : multicast frames received
0 : frames sent deferred
0 : frames sent, single collision
0 : frames sent, multiple collision
0 : send failures
0 : send failure bitmap
0 : receive failures
0 : receive failure bitmap
0 : unrecognized destinations
0 : data overruns
0 : unavailable system buffers
0 : unavailable user buffers
Note:
The counter values will have values other than zero after an
Ethernet boot.
Entering a Specific Address
To enter a specific address, use the go command. To use the go
command, type go pc and press Return.
Replace pc with the specific address where you want to enter.
If you do not specify an entry address, the system enters the
address of the most recently loaded program module. If no
module was loaded, the system enters at address 0.
E–24 Console Commands Generated by Version PDE3 ROM Chips