
V1.0
20170825
72
7. Troubleshooting
7.4 Changing Activated Carbon Filtration Net
•
As indicated by the left figure, remove
the filtration net modules along the blue
arrow direction.
•
As indicated by the left figure, open the
stamping parts around the filtration net
along the red arrow direction.
•
As indicated by the left figure, push the
activated carbon filtration net upwards
by 5 mm (make the activated carbon
filtration net detached from the inferior
card slot). After the removal, install the
new activated carbon filtration net.
•
Close the stamping parts around the
filtration net along the negative direction
of the red arrow as indicated in the
second step, and tightly lock the filtration
net.
•
As indicated by the left figure, insert the
assembled filtration net modules into the
installation site of filtration network along
the blue arrow direction.
During the insertion of filtration net modules, pay attention to the
position of the runner stamping parts and rollers. After
installation, the upper and lower gliding is smooth without
blockage.
No projection is observed in the butt end of the host shell which is
parallel and level to the upper end of the filtration net modules.
Fig.63