
V1.0
20170825
20
5. Use
5.1 Starting the Apparatus
Before the apparatus is connected to the wall socket, ensure that the main switch
at the left bottom of the apparatus is at the OFF (”0”) position.
•
Connect the power line with the wall socket, and then turn
on the power switch of the wall socket (if applicable).
•
Turn on the main switch (ON) (”I”).
•
After being started, the apparatus takes several seconds
for initialization. The progress bar about initialization
status is displayed in blue in the form of percentage (Fig.
13).
•
About 30 seconds later, the human-computer interaction
system is displayed (see chapter 5.2).
Shutdown
The system provides two shutdown methods: soft shutdown and hard shutdown.
•
Soft shutdown: When the apparatus has no running program ,
press the shutdown button on the lower-right side to close
the human-machine interaction system. When the apparatus
has a running program, the machine cannot be shut down.
When the shutdown button is pressed, the message
“program is running and the system cannot be shut down
temporarily” pops up.
•
Hard shutdown: Turn off the main switch on the left side (“0”).
Fig.13
Be careful!
The apparatus must be connected to grounded main electrical outlet.
As an additional electrical protective measure, it is suggested that the power
line of the slide stainer be inserted into the wall socket with effective protection
of disconnection in case of circuit failure.