Cupra ATECA, Руководство пользователя, Страница: 45 / 380

Self-help
torque, they could come loose while driv-
ing.
●
Never loosen the screwed joints of wheel
rims with bolted ring trims.
●
If wheel nuts are tightened below the
prescribed torque, the bolts and rims could
come loose while driving. If tightening tor-
que is too high, the wheel nuts or threads
can be damaged.
Raise the vehicle
Fig. 33
Jack position points.
Fig. 34
Cross member: positioning the jack on the
vehicle.
●
Place the jack* (vehicle tools) on firm
ground. If necessary use a large, strong
board or similar support. If the surface is slip-
pery (for example tiles) place the jack on a
rubber mat or similar to prevent it from slip-
ping
›››
.
● Find the support point on the strut (sunken
area) closest to the wheel to be changed
›››
Fig. 33
.
●
Turn the jack* crank handle, located below
the strut support point, to raise it until the
tab
1
›››
Fig. 34
is below the housing provi-
ded.
●
Align the jack* so that tab
1
“grips” onto
the housing provided on the strut and the
mobile base
2
is resting on the ground. The
base plate
2
should fall vertically with re-
spect to the support point
1
.
●
Continue turning the jack* until the wheel
is slightly lifted off the ground.
WARNING
The factory-supplied jack* is only designed
for changing wheels on this model. On no
account attempt to use it for lifting heavier
vehicles or other loads. Risk of injury.
●
Make sure that the jack* remains stable.
If the surface is slippery or soft, the jack*
could slip or sink, respectively, with the re-
sultant risk of injury.
●
Only raise the vehicle with the jack* sup-
plied by the manufacturer. Other jacks,
even those approved for other CUPRA
models could slip, with the consequent risk
of injury.
●
Only mount the jack* on the support
points designed for this purpose on the
strut, and always align the jack correctly. If
you do not, the jack* could slip as it does
not have an adequate grip on the vehicle:
risk of injury!
●
You should never place a body limb such
as an arm or leg under a raised vehicle that
is solely supported by the jack.
●
If you have to work underneath the vehi-
cle, you must use suitable stands addition-
ally to support the vehicle, there is a risk of
accident!.
●
Never raise the vehicle if it is tilting to one
side or the engine is running.
●
Never start the engine when the vehicle is
raised. The vehicle may come loose from
the jack due to the engine vibrations.
»
43