
Lights
Switching the main beam assist on
●
Turn on the ignition and turn the light
switch to the position
.
●
From the base position, press the turn sig-
nal and main beam headlights lever forwards
3
When the lamp
is displayed
on the instrument panel display, the main
beam assist is switched on.
Switching the main beam assist off
●
Turn the light switch to a position other
than
●
OR:
while the main beam is on, pull the
turn signal light and main beam headlights
lever forwards
4
.
●
OR:
push the turn signal and main beam
headlight lever forwards to manually turn on
the main beam. The main beam assist will
then be deactivated.
Malfunctions
The following conditions may prevent the
main beam headlight control from turning
off the headlights in time or from turning off
altogether:
●
In poorly lit towns with highly reflective
signs.
●
Other insufficiently lit road users (such as
pedestrians or cyclists).
●
On tight bends and steep slopes (bumps)
and when oncoming vehicles are partially
obscured.
●
When the drivers of other oncoming vehi-
cles (such as a truck) can see over a guard
rail in the centre of the road.
●
If the camera is damaged or the power
supply is cut off.
●
In fog, snow and heavy rain.
●
With dust and sand turbulence.
●
With loose gravel in the field of vision of
the camera.
●
When the field of vision of the camera is
misted up, dirty or covered by stickers, snow,
ice, etc.
WARNING
The convenience features of the main
beam assist should not encourage the tak-
ing of risks. The system is not a replace-
ment for driver concentration.
●
You are always in control of the main
beam and adapting it to the light, visibility
and traffic conditions.
●
It is possible that the main beam head-
light control does not recognise all driving
situations and is limited under certain cir-
cumstances.
●
When the field of vision of the camera is
dirty, covered or damaged, operation of
the main beam control may be affected.
This also applies when changes are made to
the vehicle lighting system, for example, if
additional headlights are installed.
CAUTION
To avoid affecting the operation of the sys-
tem, take the following points into consid-
eration:
●
Clean the field of vision of the camera
regularly and make sure it is free of snow
and ice.
●
Do not cover the field of vision of the
camera.
●
Check that the windscreen is not dam-
aged in the area of the field of vision of the
camera.
Note
Main beam and headlight flasher can be
turned on and off manually at any time with
the turn signal and main beam lever
.
“Coming home” and “Leaving home”
function
The “Coming home” and “Leaving home”
function lights up the vehicle’s immediate
proximity when getting into and out of it in
the dark. When switched on, the front posi-
tion and dipped beam lights, tail lights and li-
cense plate light come on.
»
111
Содержание ATECA
