Cupra ATECA, Руководство пользователя, Страница: 240 / 380

Driving
WARNING
●
If the inertia mode has been switched on,
take into account, when approaching an
obstacle and releasing the accelerator ped-
al, that the vehicle will not decelerate in the
usual manner: risk of accident!
●
When using inertia mode while travelling
down hills, the vehicle can increase speed:
risk of accident!
●
If other users drive your vehicle, warn
them about inertia mode.
Note
●
The driver message
Inertia
is only dis-
played with the current consumption. In in-
ertia mode the gear will no longer be dis-
played (for example “D” or “E” will appear
instead of “D7” or “E7”).
●
The inertia mode will be automatically
disconnected on gradients steeper than
15%.
Indications on the instrument panel
display
Clutch
 Clutch overheating! Please stop!
The clutch has overheated and could be
damaged. Stop and wait for the gearbox to
cool with the engine at idling speed and the
selector lever in position
P
. When the warn-
ing lamp and the driver message switch off,
have the fault corrected by a specialised
workshop without delay. If they do not turn
off, do not continue driving. Seek specialist
assistance.
Faults in the gearbox

Gearbox: Fault! Stop the vehicle
and place the lever in the posi-
tion P.
There is a fault in the gearbox. Stop the vehi-
cle in a safe place and do not continue driv-
ing. Seek specialist assistance.

Gearbox: System fault! You may
continue driving.
Have the fault corrected by a specialised
workshop without delay.

Gearbox: System fault! You can
continue driving with restric-
tions. Reverse gear disabled
Take the vehicle to a specialised workshop
and have the fault repaired.

Gearbox: System fault! You can
continue driving in D until
switching off the engine
Park the vehicle in a safe place. Seek special-
ist assistance.

Gearbox: too hot. Adapt your
driving accordingly
Continue driving at moderate speeds. When
the warning lamp switches off, you can con-
tinue driving in a normal manner.
 Gearbox: press the brake and en-
gage a gear again.
If the warning was caused by the tempera-
ture of the gearbox, this driver message will
be displayed when the gearbox has cooled
again.
Manual release of the selector lever
Fig. 203 Gear selector lever: manual release from
the parking position.
In the event of a power failure when starting
(e.g. discharged battery), the lever will re-
main locked in position
P . To move it to posi-
tion N to move the vehicle, there is an emer-
gency release device under the centre con-
sole, on the right side. Releasing the selector
238